Kamfanin Taiwan TSMC yana faɗaɗa wuraren samar da kayayyaki ba wai kawai a Amurka da Japan ba, har ma a Jamus. Ana sa ran haɗin gwiwar ESMC, wanda ke Fab 24, wanda ake kan ginawa a yanzu, zai fara samar da kayan aiki ta amfani da fasahar sarrafa kayayyaki masu girma kafin ƙarshen shekara mai zuwa. TSMC za ta aika da kayan aikin da aka saki yayin sabunta kayan aikin Taiwan ɗinta zuwa Jamus.
Wannan labarin ya bayyana. Kamar yadda jaridar Economic Daily ta ƙasar Taiwan ta ambato, TSMC a halin yanzu tana haɓaka sassa biyu na cibiyar Fab 15 da ke Taiwan, waɗanda ke da ƙwarewa daban-daban. Fab 15A tana amfani da abin da ake kira DUV lithography, tana samar da guntuwar 28-nm da 22-nm, amma tana shirin canzawa zuwa samar da nm 4 nan gaba. Za a aika da kayan aikin da aka 'yanta don samar da guntuwar 22-nm da 28-nm zuwa Jamus.
A kusa, Fab 15B yana samar da kwakwalwan kwamfuta ta amfani da fasahar zamani ta N7+, amma nan ba da jimawa ba zai koma fasahar N5 da N3. An daɗe ana amfani da kayan aikin EUV a can, don haka wannan ƙaura abu ne mai yiwuwa. Gabaɗaya, TSMC tana shirin kashe kusan dala biliyan 3,2 wajen haɓaka Fab 15. Kamfanin Taiwan yana fuskantar ƙaruwar buƙatar ingantaccen lithography, wanda ya kai kusan kashi 75% na kuɗin shigarsa, don haka zai zubar da manyan hanyoyin aiki. A lokaci guda, bisa ga ƙa'idodin masana'antar Jamus, fasahar 28nm da 22nm suna da matuƙar buƙata, domin za a yi amfani da su don samar da kwakwalwan kwamfuta don tsarin lantarki na mota. Wannan yana buɗe damar TSMC ta aika kayan aikin Taiwan da ba a buƙata zuwa Jamus don waɗannan hanyoyin samarwa.
Sources:
source: 3dnews.ru
